So, you will need....
Something to form your lamp base:
On a recent thrifting adventure I found this really cool old music stand for just $6 and knew straight away I wanted to try a lamp conversion. It has a wonderfully grungy patina with crud and rust in all the right places:
And the following items (all available from pretty much any hardware store)…
A lamp switch:
A power outlet head:
A length of power cable:
1. I removed the sheet music holder from the top of the tripod which left a nice hollow shaft perfect for housing the power cable.
2. To securely attach the lamp switch to the tripod, I first inserted the plastic thread (which comes with the lamp switch as shown above) into the top of the shaft and glued it firmly in place (you can see what I mean by this in one of the following pics).
If your lamp base won't easily accommodate the plastic thread then put your thinking cap on for a way to make it work.
When faced with a conundrum like this, I usually just browse the hardware store isles til I find something I can adapt.
3. Once the glue dried, I inserted the power cable into the hollow shaft so it protruded from both ends.
4. I wired and attached the power outlet head to the rear end of the cable as per the packet instructions.
If you're lucky enough to have a lamp kit this step is already done for you.
5. I wired and attached the lamp switch to the top end of the cable as per the packet instructions and screwed it onto the glued-in thread.
Because the thread would only fit into the fat section at the top of the shaft, half of it was still visible once the head was attached (as can be seen above). I could have cut it down though instead decided to keep the extra length for greater stability and simply wrapped it in some twine as a camouflage.
6. I inserted a globe, turned the power on and crossed my fingers...it worked! I was momentarily blinded by light - mental note, do not stare at bulb in anticipation during testing!
7. To finish I simply added a budget K-mart linen shade.